河北升降货梯链传动的布置应注意以下几点:

1、河北升降货梯http://www.rgsjpt.com/两链轮中心连线最好成水平或与水平面成45度以下倾角。
Shandong cargo lifter best line connecting the centers of two sprocket horizontally or below 45 degrees with the horizontal angle.

2、河北升降货梯两轮轴线在同一铅垂面内时，链的下垂量集中在下端，所以要尽量避免这种垂直或接近垂直的布置，否则会减少下面链轮的有效啮合齿数，降低传动能力。河北升降货梯上、下两轮错开，使其轴线不在同一铅垂面内；中心距可调；加设张紧装置；尽可能将小链轮布置在上方。
Shandong rounds cargo lifter axis in the same vertical plane, the amount of sag chain concentrated in the lower end, so try to avoid such a vertical or near vertical arrangement, otherwise it will reduce the effective number of teeth of

the sprocket below, lower transmission capacity. Shandong cargo lifter, under two rounds of staggered, so that its axis is not in the same vertical plane; center distance adjustable; plus set tensioning device; as the small sprocket arranged above.

3、无论河北升降货梯http://www.rgsjpt.com/两轮轴线在同一水平面上或不在同一水平面上，都应使松边布置在下面，否则松边下垂量增大后，链条易与小链轮干涉或松边会与紧边相碰，此外，需经常调整中心距。
Whether Shandong cargo lifter axis in two rounds or not in the same horizontal plane in the same horizontal plane, should make the loose side arranged underneath, otherwise the amount of sag increases the loose side, chain sprocket easily with little interference or loose side will be consistent with the tight side touch, in addition, the need to constantly adjust the center distance.